An air conditioner is your home’s cooling system made in a small package. There are some parts of it that were made to cool a room instead of an entire house. Once you perform your air conditioner repair Ogden Utah, be reminded that an AC has two sides. The first one is the “interior” and the second one is the “exterior” part.
The part of an AC that can be found inside the house has components such as: evaporator coil, fan (which is responsible for blowing cool air into the room), thermostat, foam filter, and the plastic face panel.
Then there’s a panel that separates both inner and outer components. Such outer components, which can be found outside of the window, include condensing coil, compressor, and a condensing fan. A condensing coil is the one that looks like a radiator while the condenser fan is the one that blows air and cools the condensing coil during the heating.
The entire package of a Window-Mounted Air Conditioner is placed securely in a metal enclosure and sits between the inner and outer part of your room’s window.
Since you know already all the parts of an AC. Now let’s try to figure out the causes and the solution of your problem to help you with your air conditioner repair Ogden Utah.
Air Conditioner Repair Ogden Utah: Common Problems, Causes, and Solutions
1. Problem: Water is flowing from front component
What might be the cause(s):
Once you see water flowing from the air conditioner’s front panel, you may think of something. It might be possible that the pan is sloping toward the exterior portion instead into the interior part. The water that comes from the evaporator coil is then dripping into the home instead out of the back area of the package through the drain tube.
How to solve it:
Place the slop properly so that the water drips out to the rear portion.
2. Problem: Air conditioner System often turns On and Off by itself
What might be the cause(s):
There’s a problem with the temperature sensor of thermostat
How to solve it:
- Adjust the wire to make sure that the thermostat sensor is placed properly near the evaporator coil. However, don’t let it touch it.
- Check if the condenser is not ruined with leaves. Try to see also if its fins are not damaged or bent. If they are bent, you can use a fin comb to repair it.
- If the performance continues to get worse, let your unit be checked if it has a leak.
3. Problem: Air Conditioner unit doesn’t turn On
What might be the cause(s):
It’s either it’s not properly plugged or its fuse has blown.
How to solve it:
- Use well seated power plug
- Restart the breaker
- Remove the blown fuse and replace it with a new one
- If you know none of the above, contact an electrician or any related specialist
4. Unit Pops the Circuit Breaker or Blows the Fuses
What might be the cause(s):
The circuit’s size (amps) may not be adequate enough
How to solve it:
Most window-mounted Air Conditioners require 120 volts and run at 15 amp circuit. However, larger units may need a dedicated circuit and once its circuit is shared from other device, it will blow the circuit. If you’re using a window AC, what you can do to solve the problem is simply use a 20-amp dedicated circuit.
Air Conditioning Ogden Utah – Air Filter Tips for Homeowners